Vent the cooling system according to manufacturer's recommendations.
Take special care with cooling systems with electric or switchable coolant pumps. On these vehicles, venting may have to be initiated by a diagnostic device via the engine management system.
Drain as much coolant as possible. Dirt particles are from the cooling system together with the coolant.
SKF always recommends flushing the cooling system before installing a new coolant pump to avoid pre-damaging the new coolant pump.
Use a vacuum tool to fill the cooling system
Do not start the engine without coolant as there is a high risk of damaging the sensitive dynamic seal of water pump
never reuse the old coolant. Contaminants are flushed out with the coolant and should not be refilled into the cooling system. In addition, the additives contained in the coolant evaporate after a while. Therefore, always use new coolant!
Always use the coolant approved by the vehicle manufacturer!
LEXUS 161A0-29015,
LEXUS 161A0-39015,
TOYOTA 161A0-29015,
TOYOTA 161A0-39015,
TOYOTA (FAW) 161A0-29015,
TOYOTA (FAW) 161A0-39015,
TOYOTA (GAC) 161A0-39015